Comments on: Hello from Australia http://kayakbytes.com/2006/07/31/hello-from-australia/ Just another LR2 Blogs weblog Fri, 10 Dec 2010 01:55:13 +0000 http://wordpress.org/?v=2.8.4 hourly 1 By: Anton http://kayakbytes.com/2006/07/31/hello-from-australia/comment-page-1/#comment-1614 Anton Mon, 31 Jul 2006 15:34:28 +0000 http://kayakbytes.com/2006/07/31/hello-from-australia/#comment-1614 Welcome Mike! Good to have another writer here. If you have any questions about the finer points of Wordpress drop me an email at: anton at lr2 dot com. Welcome Mike!

Good to have another writer here. If you have any questions about the finer points of Wordpress drop me an email at: anton at lr2 dot com.

]]> By: Tony http://kayakbytes.com/2006/07/31/hello-from-australia/comment-page-1/#comment-1613 Tony Mon, 31 Jul 2006 13:42:26 +0000 http://kayakbytes.com/2006/07/31/hello-from-australia/#comment-1613 Mike, If you get within 1 mm, that will be fine. Your strong-back will deflect more than that if you try to put too many strips on one side before going to the other. Most critical is getting the forms aligned horizontally and vertically. Copy a vertical line at the center (centre?) of each form and a horizontal line that is the water line or referenced to the water line that is visible on all forms. This helps in setting the forms up on the strong-back. Good to see your first post! Tony Olsen Mike,
If you get within 1 mm, that will be fine. Your strong-back will deflect more than that if you try to put too many strips on one side before going to the other. Most critical is getting the forms aligned horizontally and vertically. Copy a vertical line at the center (centre?) of each form and a horizontal line that is the water line or referenced to the water line that is visible on all forms. This helps in setting the forms up on the strong-back.
Good to see your first post!

Tony Olsen

]]>